Mac Filter Screen - ZyXEL Communications LTE4506-M606 User Manual

Table 17 Wi-Fi > Wi-Fi Settings
LABEL
Encryption
Mode
SSID Visibility
Wi-Fi Network
Mode
Channel Width
Channel
Encryption Type
Encryption Key
Apply
Reset

5.4 MAC Filter Screen

This screen allows you to configure the LTE4506 to exclude specific devices from accessing the
LTE4506 (Deny). Every Ethernet device has a unique MAC (Media Access Control) address. The
Chapter 5 Wi-Fi
DESCRIPTION
Select WPA, WPA2, or WPA/WPA2 to add security on this wireless network. The wireless
clients which want to associate to this network must have same wireless security settings as
the LTE4506. When you select to use a security, additional options appears in this screen.
Select WPA/WPA2 to allow wireless devices that support either WPA or WPA2 to connect to
your LTE4506's wireless network.
Select WPA to allow only wireless devices that support WPA to connect to your LTE4506's
wireless network.
Select WPA2 to allow only wireless devices that support WPA2 to connect to your LTE4506's
wireless network.
Or you can select NO ENCRYPTION to allow any client to associate this network without
any data encryption or authentication.
Select Disable to hide the SSID in the outgoing beacon frame so a station cannot obtain the
SSID through scanning using a site survey tool. Otherwise, select Enable.
If you set Wireless Band to 2.4GHz, you can use the 802.11 mode from the following:
• 802.11 bgn: allows IEEE802.11b, IEEE802.11g and IEEE802.11n compliant WLAN
devices to associate with the LTE4506. The transmission rate of your LTE4506 might be
reduced.
If you set Wireless Band to 5GHz, you can use the 802.11 mode from the following:
• 802.11a/n/ac: allows IEEE802.11n, IEEE802.11a and IEEE 802.11c compliant WLAN
devices to associate with the LTE4506.
This field displays the wireless channel width used by LTE4506.
A standard 20MHz channel offers transfer speeds of up to 144Mbps (2.4GHz) or 217Mbps
(5GHZ) whereas a 40MHz channel uses two standard channels and offers speeds of up to
300Mbps (2.4GHz) or 450Mbps (5GHZ).
Set the channel depending on your particular region.
Select a channel or use Auto Channel to have the LTE4506 automatically determine a
channel to use. If you are having problems with wireless interference, changing the channel
may help. Try to use a channel that is as many channels away from any channels used by
neighboring APs as possible. The channel number which the LTE4506 is currently using then
displays next to this field.
The following fields are available if you set Encryption Mode to WPA, WPA2, or WPA/
WPA2.
Select the encryption type (AES-CCMP or AUTO) for data encryption.
Select AES-CCMP if your wireless clients can all use AES-CCMP.
Select AUTO (TKIP+AES-CCMP) to allow the wireless clients to use either TKIP or AES-
CCMP.
Select ASCII in order to enter ASCII characters as WEP key. Select HEX in order to enter
hexadecimal characters as a WEP key.
Click Apply to save your changes back to the LTE4506.
Click Reset to reload the previous configuration for this screen.
LTE4506 User's Guide
37