Virtual Interfaces Add/Edit - ZyXEL Communications UAG2100 User Manual

10.7.1 Virtual Interfaces Add/Edit

This screen lets you configure IP address assignment and interface parameters for virtual
interfaces. To access this screen, click the Create Virtual Interface icon in the Ethernet, VLAN, or
bridge interface summary screen.
Figure 81 Configuration > Network > Interface > Create Virtual Interface
Each field is described in the table below.
Table 64 Configuration > Network > Interface > Create Virtual Interface
LABEL
Interface Properties
Interface Name
Description
IP Address
Assignment
IP Address
Subnet Mask
Gateway
Metric
Interface
Parameters
Egress
Bandwidth
Chapter 10 Interfaces
DESCRIPTION
This field is read-only. It displays the name of the virtual interface, which is
automatically derived from the underlying Ethernet interface, VLAN interface, or bridge
interface.
Enter a description of this interface. It is not used elsewhere. You can use alphanumeric
and
()+/:=?!*#@$_%-
Enter the IP address for this interface.
Enter the subnet mask of this interface in dot decimal notation. The subnet mask
indicates what part of the IP address is the same for all computers in the network.
Enter the IP address of the gateway. The UAG sends packets to the gateway when it
does not know how to route the packet to its destination. The gateway should be on the
same network as the interface.
Enter the priority of the gateway (if any) on this interface. The UAG decides which
gateway to use based on this priority. The lower the number, the higher the priority. If
two or more gateways have the same priority, the UAG uses the one that was
configured first.
Enter the maximum amount of traffic, in kilobits per second, the UAG can send through
the interface to the network. Allowed values are 0 - 1048576.
UAG2100 User's Guide
141
characters, and it can be up to 60 characters long.