ZyXEL Communications UAG2100 User Manual page 393

The following table describes the labels in this screen.
Table 194 Configuration > System > SNMP
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the Service Control table to access the UAG using this service.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Get Community Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Set Community Enter the Set community, which is the password for incoming Set requests from the
management station. The default is private and allows all requests.
Trap
Community Type the trap community, which is the password sent with each trap to the SNMP manager.
The default is public and allows all requests.
Destination Type the IP address of the SNMP manager to which your SNMP traps are sent.
Trap CAPWAP Select this option to have the UAG send a trap to the SNMP manager when a managed AP is
Event connected to or disconnected from the UAG.
Service Control This specifies from which computers you can access which UAG zones.
Add Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry. Refer to
Edit Double-click an entry or select it and click Edit to be able to modify the entry's settings.
Remove To remove an entry, select it and click Remove. The UAG confirms you want to remove it
before doing so. Note that subsequent entries move up by one when you take this action.
Move To change an entry's position in the numbered list, select the method and click Move to
display a field to type a number for where you want to put it and press [ENTER] to move
the rule to the number that you typed.
# This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the UAG's (non-configurable) default
policy. The UAG applies this to traffic that does not match any other configured rule. It is
not an editable rule. To apply other behavior, configure a rule that traffic will match so the
UAG will not have to use the default policy.
Zone This is the zone on the UAG the user is allowed or denied to access.
Address This is the object name of the IP address(es) with which the computer is allowed or denied
to access.
Action This displays whether the computer with the IP address specified above can access the UAG
zone(s) configured in the Zone field (Accept) or not (Deny).
Apply Click Apply to save your changes back to the UAG.
Reset Click Reset to return the screen to its last-saved settings.
Chapter 40 System
Table 188 on page 372
UAG2100 User's Guide
393
for details on the screen that opens.