ZyXEL Communications UAG2100 User Manual page 278

Maximize Bandwidth Usage
Maximize bandwidth usage allows applications with maximize bandwidth usage enabled to "borrow"
any unused bandwidth on the out-going interface.
After each application gets its configured bandwidth rate, the UAG uses the fairness- based
scheduler to divide any unused bandwidth on the out-going interface amongst applications that
need more bandwidth and have maximize bandwidth usage enabled.
Unused bandwidth is divided equally. Higher priority traffic does not get a larger portion of the
unused bandwidth.
Bandwidth Management Behavior
The following sections show how bandwidth management behaves with various settings. For
example, you configure LAN1 to WAN policies for FTP servers A and B. Each server tries to send
1000 kbps, but the WAN is set to a maximum outgoing speed of 1000 kbps. You configure policy A
for server A's traffic and policy B for server B's traffic.
Figure 186 Bandwidth Management Behavior
Configured Rate Effect
In the following table the configured rates total less than the available bandwidth and maximize
bandwidth usage is disabled, both servers get their configured rate.
Table 130 Configured Rate Effect
POLICY CONFIGURED RATE
A 300 kbps
B 200 kbps
Priority Effect
Here the configured rates total more than the available bandwidth. Because server A has higher
priority, it gets up to it's configured rate (800 kbps), leaving only 200 kbps for server B.
Table 131 Priority Effect
POLICY CONFIGURED RATE
A 800 kbps
B 1000 kbps
Chapter 30 Bandwidth Management
BWM
1000 kbps
1000 kbps
1000 kbps
MAX. B. U. PRIORITY
No
No
MAX. B. U. PRIORITY
Yes
Yes
UAG2100 User's Guide
278
ACTUAL RATE
1 300 kbps
1 200 kbps
ACTUAL RATE
1 800 kbps
2 200 kbps