Setup Tool Ports - Omron E5C series User Manual

3 Part Names and Basic Procedures
Key
Mode Key
M
Down Key and Up
Key
D
U
Shift Key (PF Key)
S

Setup Tool Ports

Setup Tool
port
Setup Tool port
(card edge type)
Setup Tool port
(pin jack)
Setup Tool port
(pin jack)
3 - 8
Name Overview
Changes the
parameter that is
displayed within a
setting level.
Set the value.
Operates as a
user-defined
function key.
000
Name
Use the E58-CIFQ2 USB-Serial Conversion Cable to connect the E5@C to
the computer (i.e., the CX-Thermo Support Software).
E5CC/EC/AC: On top panel
E5DC: On bottom panel
E5GC: On left side panel
Use the E58-CIFQ2 USB-Serial Conversion Cable and the E58-CIFQ2-E
Conversion Cable to connect the E5EC or E5AC to the computer (i.e., the
CX-Thermo Support Software).
E5EC/E5AC: On front panel
Use the E58-CIFQ2 USB-Serial Conversion Cable and the E58-CIFQ2-E
Conversion Cable to connect the E5DC or E5GC to the computer (i.e., the
CX-Thermo Support Software).
E5DC: On front panel
E5GC: On bottom panel
Description
• Press once to go to the next parameter.
• Hold to go to the previous parameter.
• Hold the key to increment or decrement the value
quickly.
• Any changes in settings are applied at the following
times:
• After 3 seconds elapse
• When the M Key is pressed
• When the level is changed with the O Key
• Press the S Key for less than 1 second to select the
digit to change. The key operates as a Shift Key to
change the digit by one digit every time you press the
key (default setting).
• You can change the PF Setting parameter in the
Advanced Setting Level to assign any of the following
functions to the S Key.
Run/stop, auto/manual, autotune, cancel alarm latch,
display monitor/setting item, or digit shift (default)
Example: If you set the PF Setting parameter in the
Advanced Setting Level to stop, operation will be
stopped when you press the S Key for 1 second or
longer.
• If you set pfdf (monitor/setting items), each time
you press the S Key for less than 1 second, the
display is changed in order for the items that are set
for the Monitor/Setting Item 1 to 5 parameters.
Description
E5@C Digital Temperature Controllers User's Manual (H174)