Omron E5C series User Manual page 46

2 Preparations
Mounting to a Panel
E5DC
(1) Insert the E5DC into the mounting hole in the panel. (Attach the Terminal Unit after you
insert the Main Unit.)
(2) Push the Adapter from the Terminal Unit up to the panel, and temporarily fasten the E5DC.
(3) Tighten the two fastening screws on the Adapter. Alternately tighten the two screws little by
little to maintain a balance.
Tighten the screws to a torque of 0.29 to 0.39 N·m.
E5GC
Mounting to the Panel
(1) When waterproofing is required, insert the Waterproof Packing on the backside of the front
panel. Digital Controllers cannot be waterproofed when they are mounted side by side.
Waterproof packing is not necessary when there is no need for the waterproofing function.
(2) Insert the E5GC into the mounting hole in the panel.
(3) Use two Adapters, either on the top and bottom or on the right and left.
(4) Push the Adapter from the terminals up to the panel, and temporarily fasten the Digital
Controller.
(5) Tighten the two fastening screws on each Adapter. Alternately tighten the two screws little
by little to maintain a balance. Tighten the screws to a torque of 0.29 to 0.39 N·m.
2 - 12
Y92F-53 Adapter
(Sold separately.)
Terminal Unit
Main Unit
Panel
Waterproof packing
Panel
Adapter
Terminal block
E5@C Digital Temperature Controllers User's Manual (H174)