Aastra 480i Administrator's Manual page 486

IP Phone Administrator Guide
How to Create an XML Application
Beep Option
You can enable or disable a BEEP option using the Status Message object
(AastraIPPhoneStatus), the configuration files, or the Aastra Web UI.
When the phone receives a status message, the BEEP notifies the user that the
message is being displayed. The following attribute in the AastraIPPhoneStatus
object enables/disables the BEEP from being heard:
< AastraIPPhoneStatus
This attribute is optional. If notification is required, the attribute must be in the
ROOT. If the BEEP attribute is set to "yes" (i.e. Beep="yes") then it is an
indication to the phone to sound a beep when it receives the object. If the Beep
attribute is set to "no" (i.e. Beep="no") or not present, then the default behavior is
no beep is heard when the object arrives to the phone.
Scroll Delay Option
The IP phones support a scroll delay option that allows you to set the time delay,
in seconds, between the scrolling of each status message on the phone. The default
time is 5 seconds for each message to display before scrolling to the next message.
You can configure this option via the configuration files or the Aastra Web UI.
Changes are dynamic and apply to the phone immediately.
G-16
DFW Phone 972-992-4600
Note: For enabling/disabling a status message beep using the
configuration files and the Aastra Web UI, see
"Enabling/Disabling a Beep for Status Message Displays"
Beep="yes|no">
Note: The value set in the configuration files and Aastra Web UI override
the attribute you specify for the AastraIPPhoneStatus object.
Note: For more information about setting the scroll delay option, see
Chapter 5, the section, "Scroll Delay Option for Status Messages"
page 5-89.
Chapter 5, the section,
on page
(case sensitive)
41-001129-00 Rev 09, Release 1.4.1
5-88.
on