Aastra 480i Administrator's Manual page 126

IP Phone Administrator Guide
Operational Features
By default, the softkeys display in the states of idle, connected, incoming, and
outgoing. All states are enabled.
You can enable or disable the softkey states using the configuration files or the
Aastra Web UI.
In the Aastra Web UI, the operational states for each softkey display enabled. To
disable a state, you uncheck the box for that operational state.
In the configuration files, you use the following parameters to enable and disable
operational states:
• softkeyN states
You can enter multiple values (idle, connected, incoming, outgoing) for the
"softkeyN state" parameter. For example:
softkeyN states: idle connected
You must associate the softkeyN state parameter with a specific softkey. In the
following example, the softkeyN states parameter is associated with softkey 12:
softkey12 type: speeddial
softkey12 label: voicemail
softkey12 value *89
softkey12 states: outgoing
5-14
DFW Phone 972-992-4600
Notes:
1. For softkey types Line, DND, speeddial, BLF, BLF List, XML, lcr,
empty, applicable states are "idle, connected, incoming, outgoing".
2. For softkey type Flash, applicable states are <blank>.
3. For softkey type, Spre, applicable state is "connected".
3. For softkey type Park, applicable state is "connected".
4. For softkey type Pickup, applicable states are "idle, outgoing".
Note: The IP phone idle screen condenses the softkeys. So in the
previous example, softkey 12 will appear in position 1 if no other
softkeys are set. A softkey type of "empty" does not display on the idle
screen at all. (For more information about the softkey type of "empty"
see Appendix A, the section,
page A-94.
"Softkey Settings for 480i and 480i CT"
41-001129-00 Rev 09, Release 1.4.1
on