Recording Onto Cassette Tape - Kenwood RDX-VH7 Instruction Manual

44

Recording onto cassette tape

Note that this cassette deck cannot record onto Metal tapes.
Note Note
Tape exposed side
Cassette deck
input
Select an input source other
than "TAPE" input.
O.T.E.
4 4
Temporary stop during recording
1. Load a tape in deck.
Insert the cassette straight into the insertion slot. Just push lightly
and the cassette will be pulled automatically inside.
÷ Normal (TYPE I) or high (TYPE II) tape selection is set automatically.
÷ It is not recommended to use a 100-minute or longer cassette tapes, for
these tapes are very thin and may easily cause troubles such as entangle-
ment and cutting.
÷ Remove tape slack before loading.
÷ Avoid using tapes of which the label is not firmly adhered.
2. Select the tape transport direction.
1
Press the "3 fwd" or "2 rev"
key for the direction to be
2 2
played .
2
Press the "7 stop" key.
÷ Wind the tape to the position where recording is to be started.
3. Select the source to be recorded.
TUNER (Radio broadcasting)
CD
MD
TAPE (Recording is impossible.)
AUX
÷ When the CD or MD input is selected while a
disc has already been loaded in the source com-
ponent, it starts to play; press the "7 stop" key
to stop it immediately.
1 1
2 2
5 5
To end recording
Recording onto cassette tape
RD-VH7/X-VH7 (EN)
Y
Y
direction
Lights
01
0:00
›
§
MUTE
TRACK
N.B.I
PROG.1 2
A.P.S.
#
TA NEWS
PURE A
The selected record-
ing source is dis-
played.