System Configuration, Installation; System Configuration; Rd-Vh7/X-Vh7 (En - Kenwood RDX-VH7 Instruction Manual

10

System configuration, Installation

System configuration

The VH series system components can be installed either vertically on the sides (lengthwise) or horizon-
tally by stacking one component on another. If you purchased the RD-VH7 alone, install it properly by also
referring to the instruction manuals of the components to which it is connected.
RD-VH7 + DM-VH7+ X-VH7
(Amplifier-tuner/ CD player, MD recorder, Cassette deck )
(Horizontally stacked installation)
With the horizontally stacked installation, be sure to use
the provided spacer.
Note Note
(Vertical, lengthwise installation)
Place each component so that its
LCD comes at the bottom as shown
in the illustration.
Be sure to change the feet before
vertical installation.
CAUTION Caution for Installation
To prevent fire hazard due to overheating, be sure to observe the information on this page when install-
ing components horizontally by stacking them.
÷ The RD-VH7 incorporates a ventilation fan and should always be stacked on the top of other components.
÷ To avoid blocking heat radiation from the RD-VH7, do not place any object above it or behind the ventila-
tion hole on the rear panel.
Top : 50 cm Back panel : 10 cm
÷ Before changing the installation layout, be sure to take out the CD, MD and cassette tape from the
system components and unplug the power cords.
Notes Notes
÷ Be careful not to tilt down the system components by mistake. Otherwise the CD, MD and/or cas-
sette tape left in them may be damaged.
function indicator
Dolby NR direction
B-type C-type reverse forward
rev.mode crls pause
!
System configuration, Installation
(Layout)
!
(Layout)

RD-VH7/X-VH7 (EN)

RD-VH7
DM-VH7
X-VH7
X-VH7
DM-VH7
RD-VH7