System Connections - Kenwood DP-R4450 Instruction Manual

System connections
Make connection as shown below. When connecting the related system components, refer also to the instruction manuals
of the related components.
Do not plug in the power lead until all connections are completed.
AC voltage selector switch
(Except for some areas)
URE CLITPUT fottclecesh
CXS]
E>" | 8 (6) C— i == e e
ACI (20 Rae 2O0-2d0-
> (a € © i)
System control cord
Audio cord
To AC outlet
System control connection
When connected to an amplifier or receiver having KENWOOD
SYSTEM CONTROL terminals, system operation such as remote
control is made possible. For details, refer to the instruction manual
of the amplifier or receiver.
lf your amplifier or receiver is not equipped with the SYSTEM CON-
TROL terminals, do not connect anything to any SYSTEM CONTROL
terminals.
Do not connect the unit in any system configuration other than
specified.
Onn.
@ Be sure to insert the system control cord plugs fully into the
SYSTEM CONTROL terminals.
e lf the system contro! cord and audio cords are not connected
properly, the automatic system governing remote control and
system functions will not operate.
Notes:
1. Connect all cords firmly. lf connections are loose there could be loss of sound or noise produced,
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet.
plugging/unplugging connection cords without removal of the power cord can cause malfunctions or damage to the unit.
DP-R4450 (En) ff