Actuator - Suzuki RG250 Service Manual

ACT UATOR
• Remove the fuel tank.
• Disconnect the exhaust valve control cables
from the actuator and remove the actuator from
the chassis.
• Apply DC 12V to the Pink and Gray leads of
the actuator.
• Actuator pulley turns clockwise when
ffi
lead
connects to the Pink and
e
lead to the Gray
lead .
• When reversing the connection , pulley turns
counterclock wise.
• If the actuator shaft or pulley does not turn,
replace the actuator assembly with a new unit.
,
• Apply DC12V to the Green lead and White lead
of the actuator. Connect the
$
positive termi-
nal of the battery to the Green lead and
e
negative terminal to the White lead of the
actuator.
• Using a pocket tester (x kn range) check the
continuity between White and Yellow leads
while turning the actuator pulley slowly by
hand. Connect
Ee
probe of tester to the White
lead and - probe to the Yellow lead. If there
is no continuity point in one rotation of the
pulley. stopper sensor in the actuator is defec-
tive and replace the actuator with a new one.
• Check the continuity between White and Blue
leads in the same manner prescribed above.
Connect the
EfJ
probe of tester to White lead
and
e
probe to Blue lead.
ELECTRICAL SYSTEM 6-8
Pink
Pink Gray
Blue
--l53~"
Green
Yellow
White