Cleaning The Stainless Steel Housing; Cleaning The Bread & Cake Pan; Control Panel - Breville Gourmet Baker BBM400 Instruction Booklet

CARE ANd CLEANING yOUR BREvILLE PROdUCT
CLEANING THE STAINLESS
STEEL HOUSING
1. Wipe the exterior of the stainless steel
housing and the LCD screen with a
soft, damp cloth. A non-abrasive liquid
cleanser or mild spray solution may be
used to avoid build-up of stains. Apply
the cleanser to the sponge, not the outer
surface or LCD screen, before cleaning.
Do not use a dry paper towel or cloth to
clean the LCD screen, or use an abrasive
cleanser or metal scouring pad to clean
any part of the bread maker as these will
scratch the surface.
WARNING
Never immerse the stainless steel
housing in water or place in the
dishwasher. Take care not to allow
water or cleaning fluids to seep under
the buttons or LCD screen on the

control panel.

2. Ensure the bread maker is turned OFF
by pressing and holding the
START | CANCEL button.
Remove the power plug from the power
outlet. Allow the bread maker and all
accessories to cool completely before
disassembling and cleaning.
3. If over-spills such as flour, nuts,
raisins etc. occur in the interior baking
chamber, carefully remove them using
a soft, damp cloth. Use extreme caution
when cleaning the heating elements.
Ensure the bread maker is completely
cool then gently rub a soft, damp sponge
or cloth along the length of the heating
element. Do not use any type of cleanser
or cleaning agent.
4. Let all surfaces dry thoroughly prior to
inserting the power plug into a power
outlet.
a) The fruit and nut dispenser can be
removed from the lid for cleaning.
24
b) Close the base from inside the lid and
pull the fruit and nut dispenser straight
out of the lid. This can now be wash with
warm soapy water and dry thoroughly.
NOTE
Let all surfaces dry thoroughly prior
to inserting the power plug into a
power outlet. Never wash the fruit and
nut dispenser in the dishwasher.
CLEANING THE BREAd & CAKE PAN
1. Half fill the bread pan with warm soapy
water. A non-abrasive liquid cleanser or
mild spray solution may be used. Allow
to stand for 10–20 minutes.
NOTE
Do not immerse the outside of the
bread pan and cake pan in water
as this may interfere with the free
movement of the wingnut and drive
shaft. Wash only the interior of the
bread pan.
2. Remove the paddle and wash the inside
of the bread pan and cake pan with a soft
cloth. Do not use an abrasive cleanser or
metal scouring pad as these will scratch
the non-stick coating. Ensure there is no
baked-on residue or dough on the drive
shaft. Rinse thoroughly.
3. Let all surfaces dry thoroughly prior to
inserting into the stainless steel housing.