Cwmp Config - THOMSON TG587n Reference Manual

cwmp config

Configure the cwmpd as seen from the ACS.
SYNTAX:
cwmp config
where:
state
mode
periodicInform
periodicInfInt
sessionTimeout
noIpTimeout
maxEnvelopes
connectionRequest
connectionReqPath
connectionReqUserName
connectionReqPsswd
106
[state = <{disabled|enabled}>]
[mode = <{read-only|full}>]
[periodicInform = <{disabled|enabled}>]
[periodicInfInt = <number>]
[sessionTimeout = <number>]
[noIpTimeout = <number>]
[maxEnvelopes = <number>]
[connectionRequest = <{disabled|enabled}>]
[connectionReqPath = <string>]
[connectionReqUserName = <quoted string>]
[connectionReqPsswd = <password>]
[connectionReqAuth = <{none|basic|digest}>]
[qos-class = <number{0-15}>]
[bootdelayrange = <number>]
[upgradedelay = <{disabled|enabled}>]
[am1Termination = <{disabled|enabled}>]
[persistentSubscription = <{disabled|
enabled}>]
The state of the cwmp daemon.
Set the operation mode of the cwmp daemon.
Set periodicInform flag of the cwmp daemon.
Set the interval between two periodicInform
messages in seconds.
Set HTTP session-timeout in seconds.
Set time (in seconds) ip may be 0 after
uploading new config file.
Set the maximum number of SOAP envelopes
send within one http-message.
Set connection request flag of the cwmp
daemon.
Set the path where the cwmp daemon can be
reached.
Set the username the ACS must use to log in.
Set the password the ACS must use to log in.
cwmp Commands
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20080619-0003 v1.0