nat Commands
nat tmpladd
Add an address mapping template.
SYNTAX:
nat tmpladd
where:
intf
group
timeout
type
outside_addr
inside_addr
access_list
foreign_addr
protocol
outside_port
inside_port
mode
E-DOC-CTC-20080619-0003 v1.0
[intf = <{loop|Internet|LocalNetwork}>]
[group = <{wan|local|lan|tunnel|dmz|guest} or
number>]
[timeout = <number{0-65535}>]
[type = <{napt|nat}>]
outside_addr = <ip-range>
[inside_addr = <ip-range>]
[access_list = <ip-range>]
[foreign_addr = <ip-range>]
[protocol = <{ah|egp|esp|ggp|gre|hmp|icmp|
igmp|pup|rdp|rsvp|tcp|udp|vines|xns-idp|6to4|
ipip} or number>]
[outside_port = <port-range>]
[inside_port = <port-range>]
[mode = <{auto|inbound|outbound}>]
[weight = <number{0-255}>]
The IP interface name scope for this template.
The IP interface group scope for this template.
Lifetime (seconds) for this template.
The type of template.
The outside (typically public) IP address or index
(range for NAT).
The inside (typically private) IP address or index
(range for NAT).
The range of inside addresses the template is
restricted to.
The range of destination addresses the template
is restricted to.
The IP protocol.
The outside port number or range (only for
NAPT).
The inside port number or range (only for
NAPT).
The mode to create the portmap.
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
637