GE Security DVMRe Matrix User Manual page 46

Main Menu → Alarms → Videoloss Action
q
Use this menu to configure how the unit responds to videoloss.
Camera: Select the camera you wish to configure.
Relay 1: If enabled, the unit will activate Relay 1 when videoloss
is detected.
Relay 2: If enabled, the unit will activate Relay 2 when videoloss is
detected.
Buzzer: Use this setting to disable the videoloss buzzer activation
on a per camera basis. To disable videoloss buzzer activation on
all cameras go to the Main Menu → Alarms → Buzzer Setup menu,
described in the previous section.
Main Menu → Alarms → Pre Alarm Duration
q
During recording, the unit stores up to 5 seconds of recorded
information in a buffer. This data can be automatically retrieved when
an alarm is activated. Select the amount of time just previous to the
activation of an alarm you wish to retrieve.
Main Menu → Alarms → Notification
q
Use this menu to select:
•
Email Alarm Notification.
•
TCP/IP Notification.
Email Notification Setup
This screen allows the user to setup the types of events to be notified of, and the email addresses (up
to two) to be notified. Follow the context sensitive on-screen instructions to setup the individual fields.
Also, please note that the Region/Time Zone setting must be set correctly for Email notification to time
stamp messages accurately.
0150-0242D 46
Videoloss Action
Camera : 01
Relay 1: Disable
Relay 2: Enable
Buzzer : Enable
[CANCEL] [OK]
Pre Alarm Duration
(Time in Seconds)
05
Email
TCP/IP
GE Security DVMRe Matrix