Table of Contents
Advertisement
5
Press the 5 3 or 2 4 button to adjust the hour and
then press the MEMORY/SET button.
Press the 5 3 or 2 4 button once to advance the time
by 1 hour. Hold it down to advance continuously.
6
Press the 5 3 or 2 4 button to adjust the minutes and
then press the MEMORY/SET button.
display.
Press the 5 3 or 2 4 button once to advance the time by
1 minute. Hold it down to change the time in 5-minutes intervals.
wer on.
o confirm the time display:
T
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button.
4 button to
The time display will appear for about 10 seconds.
/SET button.
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the 5 3 or 2 4 button to display
the time.
The time display will appear for about 10 seconds.
4-hour or 12-
Note:
The "CLOCK" will appear or time will flash to confirm the time display
T button.
when the AC power supply is restored after a power failure or
unplugging the unit. If incorrect, readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK" does not
appear in step 3, step 4 (for selecting the 24-hour or 12-hour display)
will be skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 69 for details.]
2 Perform "Setting the clock" from step 1 onwards.
Note:
The clock can also be set with the remote control.
Downloaded From Disc-Player.com Sharp Manuals
3/21/07, 2:50 PM
Advertisement
Table of Contents
