ZyXEL Communications UAG5100 User Manual page 69

Table 12 Dashboard (continued)
LABEL DESCRIPTION
Number of This field displays the number of users currently logged in to the UAG. Click the icon to
Login Users
pop-open a list of the users who are currently logged in to the UAG.
Boot Status This field displays details about the UAG's startup state.
OK - The UAG started up successfully.
Firmware update OK - A firmware update was successful.
Problematic configuration after firmware update - The application of the
configuration failed after a firmware upgrade.
System default configuration - The UAG successfully applied the system default
configuration. This occurs when the UAG starts for the first time or you intentionally reset
the UAG to the system default settings.
Fallback to lastgood configuration - The UAG was unable to apply the startup-
config.conf configuration file and fell back to the lastgood.conf configuration file.
Fallback to system default configuration - The UAG was unable to apply the
lastgood.conf configuration file and fell back to the system default configuration file
(system-default.conf).
Booting in progress - The UAG is still applying the system configuration.
Drop-in Mode This field displays whether the UAG is working in drop-in mode.
Status
When the UAG is in drop-in mode, you can deploy it in your existing network without
changing the network architecture and use its multiple WAN feature to connect to more
than one ISP. See the CLI Reference Guide for how to use commands to set the UAG
interfaces to work in drop-in mode.
Interface Status If an Ethernet interface does not have any physical ports associated with it, its entry is
Summary displayed in light gray text.
Name This field displays the name of each interface.
Status This field displays the current status of each interface. The possible values depend on what
type of interface it is.
For Ethernet interfaces:
Inactive - The Ethernet interface is disabled.
Down - The Ethernet interface does not have any physical ports associated with it or the
Ethernet interface is enabled but not connected.
Up - The Ethernet interface is enabled and connected.
For PPP interfaces:
Connected - The PPP interface is connected.
Disconnected - The PPP interface is not connected.
If the PPP interface is disabled, it does not appear in the list.
Zone This field displays the zone to which the interface is currently assigned.
IP Addr/ This field displays the current IP address and subnet mask assigned to the interface. If the
Netmask
IP address is 0.0.0.0/0.0.0.0, the interface is disabled or did not receive an IP address and
subnet mask via DHCP.
If this interface is a member of an active virtual router, this field displays the IP address it
is currently using. This is either the static IP address of the interface (if it is the master) or
the management IP address (if it is a backup).
Chapter 6 Dashboard
UAG5100 User's Guide
69