Quick Setup - Panasonic KX-TVS100 Quick Installation Manual

Possible causes of this message are listed below:
The PBX is not a KX-TD series system.
Since the default PBX type for the KX-
TVS100 is set to KX-TD1232 at the
factory, this message will always appear
when connecting to another type of PBX.
The cabling between the PBX extension
ports and the VPS is not four-wire or is
improperly connected.
The PBX is a KX-TD series but does not
have the proper level of software required
to support D-PITS Integration.
The PBX is not programmed properly to
support D-PITS Integration.
Start-up completed:
1. The Power Indicator light stops blinking when the start-up has been successful.
(The delay varies according to the system's condition.)
2. "**ON LINE MODE**" is displayed.
3. System prompt > is displayed on the screen.
To enter system administration, press ENTER.
When the system administrator starts operation, the system asks for the terminal type. By choosing VT100
[2], all parameters can be set through the menu driven program.
Q S
UICK ETUP
Quick Setup provides a quick way to set the following programming items. Each of these must be initially set
to start the VPS operation.
1. PBX type
2. Extension numbers of VPS ports
3. Extension numbers for mailboxes
4. Creating mailboxes
5. Port service setting
6. Password setting
Cause
Please Select Your Terminal Type.
1. ASCII TERMINAL
2. VT100 COMPATIBLE TERMINAL
ENTER THE NUMBER := ______
Action
Change the PBX type by using
Quick Setup (see below).
Confirm the cabling is connected as
described in Chapter 2.
Contact Panasonic Parts Center
(MSC) at 1-800-833-9296
or use Inband Integration under
hardware settings.
Do required integration
programming as described in
Chapter 3.
6.60