IP Office Installation
B RI Trunk Cards (Quad BRI)
1 5 2 B
The BRI trunk card is also referred to as the "Quad BRI". It provides 4 RJ45 sockets for ETSI BRI trunk
connections, with each trunk supporting 2B+D channels.
•
The trunk card ports include 100 ohm termination.
Variant
IP400 BRI
IP400 BRI 8 (UNI) All except China
•
These cards include two plastic spacer pegs for installation and a replacement blanking plate for
the rear of the control unit. The blanking plate is not required with the Small Office Edition which
has removable sections in the rear panel.
T 1 PRI Trunk Cards
1 5 3 B
These trunk cards support 23B+D primary rate (US PRI) trunks and 24B T1 robbed-bit trunks. The mode
of operation is selected within the IP Office configuration.
The T1 PRI card includes an integral CSU/DSU that can be activated through the IP Office Monitor
application.
PRI Trunk Cards
IP400 PRI 24
T1
IP400 PRI 48
T1
•
These cards include two plastic spacer pegs for installation and a replacement blanking plate for
the rear of the control unit. The blanking plate is not required with the Small Office Edition which
has removable sections in the rear panel.
Installation Manual
IP Office 3.2
Country
All
Country
North
Supported on all control units.
America
North
Supported only on the IP412 and Slot A of
America
Control Unit
Supported on all control units.
Control Units
the IP406 V2.
15-601042 Issue 14b (13th November 2007)
SAP Code
700185168
700262017
SAP Code
700185200
700185218
Page 194