8.4.11 IP Trunk Configuration
An IP trunk to the IP Office must be configured. Only one trunk is supported.
1. In the left-hand panel select DECT. Select the Trunks tab.
2. Enter the following settings:
· Name
Set a name that identifies the IP Office system.
· Local Port
set this to 1720.
· CS IP Address
Set this field to the IP address of the IP Office system.
· CS Port
Set this to 1720.
3. Click OK.
· The message Reset required! is displayed. At this stage further changes are required so do not reset the base
station.
DECT R4
IP Office Release 7.0
15-601047 Issue 03a (21 February 2011)
Page 138