Honeywell VX3Plus Reference Manual page 93

Message
Opened status file
Out of memory for
encrypted pwd
pRealTaskbarWndProc
already set
Pwd cancelled or invalid-
remain in user mode
Read registry error-hot
key
Read registry failure-app
name
Read registry failure-
Cmd Line
Read registry failure-Inter-
net
Registering Backdoor
MSG
Registering Hotkey MSG
Registry read failure at
reenter user mode
Registry read failure at
reenter user mode
Registry read failure
Reset system work area
failure
Shift pressed
Shift
Show taskbar
Switching to admin-back-
door
Switching to admin-hot-
key press
Switching to admin-
kbdhook.dll not found
Explanation and/or corrective action
AppName value in the Administration key is not available.
The status information is being saved to a file and the file has been opened successfully.
Not enough memory to encrypt the password.
The taskbar control has already been installed.
The password prompt was cancelled by the user or the maximum number of failed
attempts to enter a password was exceeded.
The hotkey registry entry is missing or empty. This is not considered an error. The key-
board hook uses an embedded default if the value is not set in the registry.
AppName registry value does not exist or is empty. This constitutes a failure for switching
into user mode.
AppCommandLine registry entry is missing or empty. This is not considered an error
since command line information is not necessary to launch and lock the application.
The Internet registry entry is missing or empty. This is not considered an error since the
Internet value is not necessary to launch and lock the application.
The AppLock system communicates with the keyboard hook via a user defined message.
Both AppLock.exe and Kbdhook.dll register the message at initialization.
The AppLock system communicates with the keyboard hook via a user defined message.
Both Applock.exe and Kbdhook.dll register the message at initialization.
The registry has to be read when entering user mode is the AppName is missing. This
user mode entry is attempted at boot and after a hotkey switch when the administrator has
closed the application being locked or has changed the application name or command
line.
The registry has to be read when switching into user mode. This is because the admin-
istrator can change the settings during administration mode. The read of the registry failed
which means the Administration key was not found or the AppName value was missing or
empty.
The registry read failed. The registry information read when this message is logged is the
application information. It the Administration key cannot be opened or if the AppName
value is missing or empty, this error is logged. The other application information is not
required. If the AppName value is not available, AppLock cannot switch into user mode.
The system work area is adjusted when in user mode to cover the taskbar area. The sys-
tem work area has to be adjusted to exclude the taskbar area in administration mode.
AppLock was unable to adjust this area.
The Shift key has been pressed and trapped by the HotKey processing.
Processing the hotkey and backdoor entry
The taskbar is now being made visible and enabled.
The system is currently in user mode and is now switching to admin mode. The switch
occurred because of the backdoor key presses were entered by the administrator.
The system is currently in user mode and is now switching to admin mode. The switch
occurred because of a hotkey press by the administrator.
The keyboard hook load failed, so AppLock switches to admin mode. If a password is
specified, the password prompt is displayed and remains until a valid password is
entered.
Level
LOG_EX
LOG_ERROR
LOG_EX
LOG_EX
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_PROC-
ESSING
LOG_PROC-
ESSING
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_EX
LOG_PROC-
ESSING
LOG_PROC-
ESSING
LOG_PROC-
ESSING
LOG_PROC-
ESSING
3-53