Avalanche Update Using File > Settings; Menu Options - Honeywell VX3Plus Reference Manual

Avalanche Update using File > Settings
Use these menu options to setup the Avalanche Enabler on the VX3Plus. Change the settings and save them by rebooting
before connecting to the network.
Alternatively, the Mobile Device Server can be disabled until needed (refer to the Wavelink Avalanche Mobility Center
User's Guide for details).

Menu Options

Note: Your VX3Plus screen display may not be exactly as shown in the following menu options. Contact
your representative
Connection
Server Contact
Data
Preferences
Display
Taskbar
Execution
Scan Config
Shortcuts
SaaS
Adapters
Status
Startup/Shutdown
for version information and upgrade availability.
Enter the IP Address or host name of the Mobile Device Server. Set the order in which serial ports or
RF connections are used to check for the presence of the Mobile Device Server.
Setup synchronization, scheduled Mobile Device Server contact, suspend and reboot settings.
Control when data is transferred between the device and the Mobile Device Server.
Set options for Enabler startup or shutdown and logging. If the Preferences tab is not present, you
may have an older version of the Enabler with the Startup/Shutdown tab.
Set up the Windows display at startup, on connect and during normal mode. The settings can be
adjusted by the user.
Set options for Taskbar. If the Taskbar tab is not present, you may have an older version of the Ena-
bler with the Startup/Shutdown tab.
Not available in this release. Use AppLock instead, which is resident on each device.
This option allows the user to configure Enabler settings using a special bar code that is created by
the Avalanche MC Console. Scan Config not currently supported.
Add, delete and update shortcuts to user-allowable applications.
Configure the Enabler to connect with Avalanche on Demand.
Enable or disable network and wireless settings. Select an adapter and switch between the Ava-
lanche Network Profile and manual settings.
View the current adapter signal strength and quality, IP address, MAC address, SSID, BSSID and
Link speed. The user cannot edit this information.
Set options for Enabler program startup or shutdown. Replaced by Preferences and Taskbar tabs in
some versions of Enabler.
4-9