Nikon eclipse fn1 Instructions Manual page 57

Power cord
Operating conditions
Transport/storage
conditions
External dimensions
and weight (main body)
Safety standard
Eclipse FN1 and the
following equipment
were tested for the UL
certification.
• TE2-PS100W
power supply
• FN-LH lamp house
• YM-EPI, 3-3PIN
extension cable
Chapter 7
• When the supply voltage is 100 V to 120 V
UL Listed detachable cord set, 3 conductor grounding Type SVT, No.18
AWG, 3 m long maximum, rated at 125 V AC minimum.
• When the supply voltage is 220 V to 240 V
Approved according to EU/EN standards, 3 conductor grounding Type
HO5VV-F, AWG 18, 3 m long maximum, rated at 250 V AC minimum.
• To use the halogen light source LS-DWL-N (manufactured by Sumita Optical
Glass), be sure to use the provided power cord.
Temperature:
Humidity:
Altitude
Pollution degree
Installation category
Electric shock protection class
Indoor use only
-20 ° C to +60 ° C
Temperature:
Humidity: 90% RH max. (no condensation)
External dimensions:
Weight: approx. 12 kg
• This is UL-listed product. (UL61010A-1)
• This product meets FCC Part 15B Class A requirements.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference
at his own expense.
• This Class A digital apparatus complies with Canadian ICES-003.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du
Canada.
• This product complies with Australian EMC (AS/NZS CISPR11 Group 1 Class
B).
CE marking
• This product meets EU Low Voltage Directive requirements.
• This product meets EU EMC Directive requirements.(EN61326)
Specifications
+10 ° C to +40 ° C
85% RH max. (no condensation)
2000 m max.
Degree 2
Category II
Class I (TE-PS100W power supply)
214(W) x 346(H) x 422(D) mm
55