Glossary - Kyocera FS-1018MFP Advanced Operation Manual

Glossary

AppleTalk AppleTalk offers file sharing and printer sharing and it also enables you to
utilize application software that is on another computer on the same
AppleTalk network.
APS (Auto Paper Selection) When you want to copy from various sizes of originals at one time, this
mode will automatically select the size of copy paper that corresponds to
each individual original and will copying that original onto that paper size.
Cassette Mode This is an operation mode for the MP tray. When this mode is used,
approximately 50 sheets of plain paper can be fed continuously, the same
as for the cassette.
COMMAND CENTER This is the home page that is installed in this machine. It can be accessed
from a Web browser by simply entering the appropriate IP address. You
can then use the browser window to verify this machine's operating status
and make settings related to security, network printing, e-mail transmission
and advanced networking.
Default Gateway This indicates the device, such as a computer or router, that serves as the
entrance/exit (gateway) for accessing computers outside of the network
that you are on. When no specific gateway is designated for a destination
IP address, data is sent to the host that is designated as the Default
Gateway.
DHCP (Dynamic Host This is a protocol that automatically resolves the IP address, Subnet Mask
Configuration Protocol) and Gateway address on a TCP/IP network. Use of DHCP minimizes the
load of network administration, especially on network environments with a
large number of client computers where it is not specifically necessary to
assign a separate IP address to each client, including printers.
DIMM Dual Inline Memory Module.
dpi (dots per inch) This indicates the number of dots printed per inch, and is the unit of printer
and scanner resolution.
EcoPrint This is a printing mode that controls toner consumption. Pages printed in
the EcoPrint mode are lighter than pages printed in the normal mode. The
default setting is Off.
Emulation This refers to emulation of other manufacturers' printers. The printer
emulates operation of the following printers: PCL6, Line printer, IBM
Proprinter, DIABLO 630, EPSON LQ-850 and KPDL.
Expansion Memory This option is used to increase machine memory. The printer has one
expansion slot, and you can install a 64 MB, 128 MB, or 256 MB DIMM
(Dual Inline Memory Module). Contact your Kyocera Mita dealer to
purchase the DIMM that is best suited for use with this machine.
Face-up Tray This is located at the rear of the machine. Select paper delivered to the
Face-up Tray when printing on postcards, envelopes, or labels.
Appendix-16 ADVANCED OPERATION GUIDE