Kyocera FS-1018MFP Advanced Operation Manual page 180

Appendix-8
Adhesive label paper must be entirely covered by its top sheet, with no
spaces between the individual labels. Labels with spaces in between are
apt to peel off, causing serious paper jam problems.
Some label paper is manufactured with an extra margin of top sheet
around the edge. Do not remove the extra top sheet from the carrier sheet
until after printing is finished.
Acceptable
The table below lists the specifications for adhesive label paper.
Item
Weight of top sheet
Composite weight
Thickness of top sheet
Composite thickness
Moisture content
Postcards
Fan the stack of postcards and
align the edges before loading
them in the MP tray. Make sure
the postcards you are going to set
are not curled. Feeding curled
postcards may cause paper jams.
Some postcards have rough
edges on the back (those are
created when the paper is cut). In
this case, put the postcards on a flat place and rub the edges with, for
example, a ruler to smooth them.
Unacceptable
Top sheet
Carrier sheet
Specification
44 to 74 g/m² (12 to 20 lb/ream)
104 to 151 g/m² (28 to 40 lb/ream)
0.086 to 0.107 mm (3.9 to 4.2 mils)
0.115 to 0.145 mm (4.5 to 5.7 mils)
4 to 6 % (composite)
Rough Edge
ADVANCED OPERATION GUIDE
Rough
Edge