Kyocera FS-1018MFP Advanced Operation Manual page 172

Using COMMAND CENTER
Problem
I can't access the
Basic, Printer,
Scanner, and
Advanced pages.
I can't perform
settings.
The settings I
made are not
registered.
The administrator
has forgotten the
Admin password.
Error is displayed
under the STATUS
indicator
Warning is
displayed under
the STATUS
indicator
6-24
Checkpoint
Has the administrator set
a password?
Is the printer or scanner
currently in operation?
Did you click on the
Submit button after
making the settings?
Did you click on the
Restart button after
making the settings?
Some settings are not
registered until the
machine is restarted.
-
Is there an error message
shown in the message
display?
Procedure
Enter the appropriate password.
Settings are not possible while the
printer or scanner is in operation.
Wait until the operation has been
completed.
After making the desired settings,
click on the Submit button and
move to another page or close the
COMMAND CENTER window.
Restart this machine. All settings
will be registered.
If the Admin password is forgotten,
reset to factory defaults.
Follow the appropriate procedure in
the troubleshooting section of the
Basic Operation Guide that
corresponds to the error message.
Reference
page 6-8
page 6-9
page 6-11
page 6-8
Chapter 7, Basic
Operation Guide
ADVANCED OPERATION GUIDE
-