Kyocera FS-1018MFP Advanced Operation Manual page 189

Form Feed Timeout During the time that data is being sent to the printer, periodic pauses or
interruptions may be generated. However, even if the data stream is
interrupted, the printer can normally handle the next data that is sent after
a delay without making a page break between the two blocks of data.
FRPO (Firmware RePrOgram) These are commands that reset the machine's firmware. It is possible to
use this to return each of the settings that are applied when the power is
turned on to this machine back to its default value. (To temporarily change
a setting, PRESCRIBE commands should be used instead of FRPO
commands. It is possible to reset a single value with each FRPO
command. Current settings can be verified by printing out a Status Page
from this machine.
Grayscale This is one method of describing monochrome color shades on a
computer.
IEEE1284 This is a standard used when connecting a printer to a computer, and was
established by the Institute of Electrical and Electronic Engineers in 1994.
IP Address (Internet Protocol The Internet Protocol address is a unique number that represents a
Address) specific computer in a network. The format of an IP Address is four
numbers separated by dots, e.g. 192.168.110.171. Each number should
be a decimal between 0 and 255.
IPP (Internet Print Protocol) This enables output to the printer from a printer driver over the Internet or
an intranet and via an IPP port. Using IPP, output to a remote printer is
possible over the Internet.
Job This refers to an independent block of data to be processed for scanning
or printing. A command that indicates the beginning and end of each job is
included with each block of scan and print data in order to enable the
printer to differentiate that data from the data for another job.
KIR This is smoothing function. It uses software to enhance the printer's
resolution and produce high-quality printing. The default setting is On.
KPDL KPDL is Kyocera's implementation of the PostScript page description
language Level3.
Logical Printer This is a software interface that exists between the Windows OS and the
printers connected to it. A printer refers to the actual device that prints out,
while a logical printer refers to the software interface that resides on the
printer server.
Low Power Mode This mode is engaged when actions such as scan and print operations,
use of the operation panel, and transmission or reception of data do not
occur for a predetermined amount of time. At this point, the machine enters
a waiting state that automatically reduces power consumption. When a
further predetermined amount of time is exceeded, the machine will then
enter the Sleep mode.
MP tray The MP tray is used instead of the cassette when printing on envelopes,
postcards, transparency sheets, and labels.
ADVANCED OPERATION GUIDE Appendix-17