1: Autoprogram - Fire-Lite MS-9600 User Manual

Programming
PROGRAMMING
1=AUTOPROGRAM
2=POINT PROGRAM
3=ZONE SETUP
Programming Screen #1
48
3.6.1 Autoprogram
Pressing 1 while viewing Programming Screen #1, will select the Autoprogram option,
which prompts the control panel to poll all devices installed on one or both SLC loops.
The primary purpose of autoprogramming is to allow the installer a fast and easy way to
bring the system on-line as quickly as possible. The first time the system is powered-
up, it should be autoprogrammed.
If the system is already programmed and Autoprogram is initiated, the system will only
add default values for newly installed devices.
When Autoprogram is selected, the programmer is given the option of
autoprogramming all loops, only loop 1 or only loop 2. The following will be displayed
on the LCD:
1=LOOP 1
2=LOOP 2
3=ALL LOOPS
Autoprogram Loop Select Screen
After selecting one of the Autoprogram options, the control panel will begin
autoprogramming the system by communicating with each addressable device installed
on one or both loops. While autoprogramming, the panel will display the following:
AUTOPROGRAMMING!
Autoprogram Progress Screen
When Autoprogramming is completed, the control panel will display the type and
quantity of each device installed on the SLC loop(s) similar to the following display:
# OF DET LOOP1 055
# OF MON LOOP1 035
# OF CON LOOP1 030
Autoprogram Result Screen #1
# OF DET LOOP2 000
# OF MON LOOP2 000
# OF CON LOOP2 000
Autoprogram Result Screen #2
In the preceding example, the first display indicates that Loop 1 has 55 addressable
detectors, 35 monitor modules and 30 control modules installed. The second display
indicates that Loop 2 has no devices installed.
AUTOPROGRAM
AUTOPROGRAM
PLEASE WAIT
Master Programming Level
MS-9600 PN 51335:E 7/9/03