Cylinder Block Front Cover Seal; Removal; Installation - Ford LRG-423 Service Manual

02-26
Engine Service, 2.3L
02-26
2.3L ENGINE SERVICE (Continued)
FRONT COVER
SEAL REMOVER
T74P-6700-B
PPDA7081-1 B
Installation
1. Position camshaft or oil pump shaft seal on Front
Seals Replacer T74P-6850-A and press into
place.
A70834 B
2.
Remove tool.
3. Position sprocket on shaft.
4.
Install Cam Sprocket Holding/Removing Tool
T74P-6256-B, without threaded puller insert, on
sprocket.
5. Install sprocket bolt and washer and tighten to
71-95 Nom (52-70 lb-ft).
6.
Remove tool.
7.
Install timing belt as outlined in this section.
8.
install outer timing belt cover as outlined in this
section.
Cylinder Block Front Cover Seal
SPECIAL SERVICE TOOL(S) REQUIRED
Description
Tool Number
Front Cover Seal Remover
T74P-6700-B
Cam Bearing Adapter Tube
T72C-6250
,
Removal
1.
Remove outer timing belt cover as outlined in this
section.
2.
Remove timing belt as outlined in this section.
3.
Remove crankshaft pulley hub bolt.
4.
Slide crankshaft pulley (6312) off crankshaft
(6303).
5.
Slide crankshaft sprocket off of crankshaft.
6.
Remove key from crankshaft.
7.
NOTE: When positioning Front Cover Seal
Remover T74P-6700-B, make sure jaws are
gripping the thin edge of the seal tightly before
operating the jack screw portion of the tool.
Install Front Cover Seal Remover T74P-6700-B,
making sure jaws are gripping the thin edge of
the seal.
8.
Remove seal.
9. Clean journal of debris.
Installation
1. Using Cam Bearing Adapter Tube T72C-6250
and crankshaft pulley hub bolt, press engine front
cover seal into engine front cover (6019).
2.
Remove tool.
3.
Install key.
4.
Install crankshaft sprocket (6306), crankshaft
pulley, washer, and bolt. Tighten bolt to 125-I 65
Nom (92-l 21 lb-ft).
5.
Install timing belt as outlined in this section.
6.
Install outer timing belt cover as outlined in this
section.
Cylinder Head
SPECIAL SERVICE TOOL(S) REQUIRED
Description Tool Number
Camshaft Belt Tensioner Tool T74P-6254-A
Removal
1. Disconnect battery ground cable.
2.
Drain cooling system.
3.
Remove intake manifold as outlined in this
section.
4.
Remove ignition harness.
5.
Remove spark plug wire set (12281) from spark
plugs (12405) and valve cover attachments.