Ford LRG-423 Service Manual page 142

03-33 Auxiliary Systems
03-33
ZENITH MODEL #33 CARBURETOR OPERATION AND SERVICE (Continued)
15
16
17
Place intake gasket (8) in position on body.
Note: if you have an older model unit with
removable accelerator jet; after intake gasket (8)
is in place, an additional washer (55) will be
assembled over the accelerator
jet tube (47) and
set inside the large hole in the intake gasket (8)
and on top of the smaller washer (48). Lower air
intake carefully onto bowl and fasten securely
and evenly using attaching screws (5).
Place accelerator pump diaphragm
(37) in place
on body with bagged section into cavity. Insert
diaphragm protector (38) into end of spring (39)
and install spring with protector against
diaphragm.
Place cover (40) over spring and compress.
Insert screws (41) and tighten evenly and
securely. Note: Pump spacer (57) will install into
cover before assembly if required.