Ford LRG-423 Service Manual page 169

03-60 Auxiliary Systems
03-60
GOVERNORS, REMOVAL AND INSTALLATION
Removal
Installation
1.
2.
3.
4.
5.
Disconnect hand throttle connection at governor
variable speed lever.
1.
Disconnect governor to carburetor throttle control
rod at governor.
2.
Loosen governor mounting nuts and bolts and
move governor toward engine to loosen drive
belt.
3.
4.
Remove drive belt from governor pulley.
Remove governor to bracket attaching bolts and
remove governor.
5.
Position the governor to the mounting bracket
and install the attaching bolts snugly.
Position drive belt to governor pulley and move
the governor away from the engine to tighten the
belt. Tighten the attaching bolts.
Adjust the belt tension.
Connect the governor to carburetor throttle
control rod. Adjust the rod as described
previously.
Connect hand throttle cable to governor variable
speed lever. Adjust cable as necessary to permit
operation from idle to maximum speed.