Compaq Deskpro EN Series Maintenance & Service Manual page 95

7. Remove the cable from the cable tie mounted on the side of the chassis.
8. Remove the LED from the power switch bracket by pulling gently on the LED while at the
same time prying open the LED retaining ears.
When installing the LED into a new mounting bracket, the black wire should be in
the top socket and the white wire in the bottom socket. This is marked on the rear
of the mounting bracket.
CAUTION: Compaq does not recommend removing the switch from the mounting bracket.
To install the switch cable assembly, reverse the removal steps.
Refer to the markings on the front of the chassis for proper placement of the LED
lights.
Compaq Deskpro EN Series, Small Form Factor and Net PC Models 5-27