Compaq Deskpro EN Series Maintenance & Service Manual page 139

SCSI Test Error Codes
xxxx-30 Controller timed out.
xxxx-31 Unrecoverable error.
xxxx-32 Controller/drive disconnected.
xxxx-33 Illegal controller command.
xxxx-34 Invalid SCSI bus phase.
xxxx-35 Invalid SCSI bus phase.
xxxx-36 Invalid SCSI bus phase.
xxxx-39 Error status from drive.
xxxx-40 Target timed out.
xxxx-41 SCSI bus stayed busy.
xxxx-42 ACK/REQ lines bad.
xxxx-43 ACK did not deassert.
xxxx-44 Parity error.
xxxx-50 Data pins bad.
xxxx-51 Data line 7 bad.
xxxx-52 MSG, C/D, and/or I/O lines bad.
xxxx-53 BSY never went busy.
xxxx-54 BSY stayed busy.
xxxx-60 Controller CONFIG-1 register bad.
xxxx-61 Controller CONFIG-2 register bad.
xxxx-65 Media not unloaded.
xxxx-90 Fan failure.
xxxx-91 Over Temperature.
xxxx-99 Autoloader reported tapes not loaded
properly.
Replace indicated device. (xxxx-30 through
xxxx-65)
1. Ensure fan(s) connected.
2. Replace nonfunctional fan(s).
1. Ensure proper air flow.
2. Perform required maintenance and cleaning.
1. Install tape(s) in autoloader tape drive
according to test instructions.
2. Change autoloader magazine.
Compaq Deskpro EN Series, Small Form Factor and Net PC Models D-9