Compaq Deskpro EN Series Maintenance & Service Manual page 106

CAUTION: Check the position of all cables and wires before raising or lowering the drive cage to
prevent cable damage.
9. Return the drive cage to the normal position.
10. If you have installed an audio board to the computer, attach the audio cable from the system
board at J11 to the audio board at this time.
11. If it is necessary to remove the expansion board cage to attach the audio cable, refer to
Section 5.9.
Attaching the Audio Cable to the System and Audio Boards
12. Remove the bezel blank from the front bezel (Section 5.16.3).
13. Install the system unit cover (Section 5.7).
14. The system will automatically recognize the Slimline CD-ROM drive sold by Compaq, then
will automatically reconfigure the computer.
If you have installed a third-party drive that is not a plug and play device, you must run
Computer Setup to reconfigure the computer. Refer to Chapter 2, "Software Reference," for
information on running Computer Setup.
CAUTION: When servicing the computer, ensure that cables are placed in their proper locations during
the reassembly process. Improper cable placement can damage the computer
5-38 Removal & Replacement Procedures