Compaq Deskpro EN Series Maintenance & Service Manual page 90

5. Slide the system board about 1- to 2-inches (2.5- to 5.1-cm) out of the rear of the chassis.
It is not necessary to disconnect any cables from the system board for this
operation.
6. Press outward on both latches of the DIMM socket at the same time. This releases the module
and partially pushes it out of the socket.
7. Lift the module from the socket.
Replacing a Memory Module
To replace a DIMM, reverse the removal steps.
CAUTION: Check the position of all cables and wires before raising or lowering the drive cage to
prevent cable damage.
When the computer starts up, it will recognize the system memory upgrades and
automatically reconfigure the computer.
5-22 Removal & Replacement Procedures