Epson TM-T90 Specification page 49

Confidential
4) Drawer open/close signal
Input signal level (connector pin 3):
F. G
A
B
NOTES: 1. Use a shielded cable for the drawer connector cable.
2. Two driver transistors cannot be energized simultaneously.
3. The drawer drive duty must be as shown below.
(ON time + OFF time)
4. Be sure to use the printer power supply (connector pin 4) for the drawer power source.
5. The resistance of the drawer kick-out solenoid must not be less than the specified
resistance. Otherwise, an overcurrent could damage the solenoid.
6. Do not connect telecommunication network to the drawer kick-out connector.
EPSON
Drawer kick-out connector
1
2
3
+24V
4
P-GND
5
6
P-GND
Printer side
Figure 2.2.4 Drawer Circuitry
ON time
≤ 0.2
TITLE
TM-T90
Specification
(STANDARD)
"L" = 0 to 0.8 V
"H" = 2 to 5 V
With shielded
Drawer kick-out solenoid
User side (Drawer kick-out side)
SHEET
REVISION
F
Drawer open/close switch
NO.
NEXT SHEET
32 31