Epson TM-T90 Specification page 209

Confidential
NOTES: 1. Since the specified thermal paper dimension of the outside diameter of roll paper in
Table C.1 is a calculated value, there may be some variations depending on the
printer.
2. Be sure that the detection lever operates smoothly after you finish the adjustment.
3. Change the paper roll near-end sensor position, to detect the paper near-end
correctly when the printer is attached to a wall. (Refer to Figure C.2)
• Loosen the screw for the detector.
• Push and hold the lever on the detector as far into hole 1 as possible.
• Press the knob inward to move the detector lever past hole 1, and then move the
• After setting the lever into hole 2, secure it with the screw.
6
knob toward the front of the printer until the lever clicks into place in hole 2.
Detection lever
Knob
Screw
Figure C.2 Changing the Near-end Adjusting Position
TITLE
TM-T90
Specification
(STANDARD)
Hole 2
Hole 1
NO.
SHEET
REVISION
NEXT
F
App. 7
SHEET
App. 6