Printing And Cutting Positions - Epson TM-T90 Specification

Confidential
<Japanese model when the paper width is changed>
<80 mm {3.15"} paper width model>
79.5 ± 0.5 mm
0.125 mm
2.65 mm
72 mm (dot #1 ~ #576).
Figure 1.7.3 Printable Area for Japanese Model (When the Paper Width Is Changed)
NOTE: The numeric values used here are center values to be used in designing. The printable area
may be out of alignment by 2 mm maximum to the left or right, due to the paper position or
tolerance of parts.

1.8 Printing and Cutting Positions

Auto-cutter blade position
Center of the print dotline
NOTE: Numeric values used here are center values to be used in designing. The values may vary
slightly as a result of paper slack or variations in the paper. Take this into account when
setting the cutting position of the autocutter.
EPSON
576 dots
Manual-cutter position
Figure 1.8.1 Printing and Cutting Positions
TITLE
TM-T90
Specification
(STANDARD)
<60 mm {2.36"} paper width model>
59.5 ± 0.5 mm
0.125 mm
4.85 mm
2.65 mm
54.5 mm (dot #1 ~ #436)
26.3
14.8
Approx. 14
Paper feed direction
[ Units: mm (All the numeric values are typical.) ]
SHEET
REVISION
F
436 dots
2.35 mm
Approx. 29
NO.
NEXT SHEET
11 10