Installing The Computer In The Rack Enclosure - IBM IntelliStation 6866 Hardware Maintenance Manual

5.

Installing the computer in the rack enclosure

Parts needed:
•
•
•
•
40
IBM IntelliStation Type 6866: Hardware Maintenance Manual
2) From the rear of the rack enclosure, insert a long screw through holes in
the slide bracket and mounting rail; then, tighten the screws.
Attach the cable-management arm to the right rear of the rack enclosure.
a. Align the holes on the cable-management arm mounting panel with the cage
nuts on the rear mounting rail.
b. From the rear of the rack enclosure, insert a long screw through the holes in
the cable-management arm mounting panel and cage nut; then, tighten the
screws.
Notes:
1) You can choose to wait to attach the cable-management arm to the rack
until after you have attached the other end of the cable-management arm
to the computer.
2) To facilitate alignment of the cable-management arm, be sure to insert the
screws through the first and fourth holes, as shown.
Four long screws
Two cage nuts
One cable-management arm
Cable ties