Installing Options In Your Computer; Major Components Of Your Computer - IBM IntelliStation A Pro Installation Manual

v Each of the drive bays has a drive or a filler panel and electromagnetic
v There is adequate space around the computer to allow the computer cooling
v You have followed the cabling instructions that come with optional adapters.
v You have replaced a failed fan as soon as possible.
Handling static-sensitive devices
Attention:
avoid damage, keep static-sensitive devices in their static-protective packages until
you are ready to install them.
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions:
v Limit your movement. Movement can cause static electricity to build up around
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed printed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the computer
v Take additional care when handling devices during cold weather. Heating reduces

Installing options in your computer

This section provides instructions for installing hardware options in your computer.

Major components of your computer

The following illustration shows the major components in the A Pro Type 6224
computer.
compatibility (EMC) shield installed.
system to work properly. Leave approximately 50 mm (2 in.) of open space
around the front and rear of the computer. Do not place objects in front of the
fans. For proper cooling and airflow, replace the computer cover before turning
on the computer. Operating the computer for extended periods of time (over 30
minutes) with the computer cover removed might damage computer components.
Static electricity can damage electronic devices and your system. To
you.
metal part of the system unit for at least 2 seconds. This drains static electricity
from the package and from your body.
without setting down the device. If it is necessary to set down the device, put it
back into its static-protective package. Do not place the device on your computer
cover or on a metal surface.
indoor humidity and increases static electricity.
Chapter 2. Installing the hardware
11