IBM IntelliStation 6866 Hardware Maintenance Manual page 46

2.
3.
38
IBM IntelliStation Type 6866: Hardware Maintenance Manual
c. Remove the tape from the mounting rails, and attach the template to the rear
mounting rails. Mark the locations for the slide brackets and cage nuts.
Notes:
1) Align the slide brackets correctly, or the installation cannot be completed.
2) The slide rails have four screws each to allow for length adjustment.
Install the cage nuts in the marked positions as shown.
Attach the slide rail to the left side of the rack enclosure.
a. Extend the outer slide rail until the slide bracket is flush against the outside of
the left front mounting rail. Align the slide rail with the cage nuts on the
mounting rail.
b. From the front of the rack enclosure, insert two long screws through the slide
bracket and mounting rail. Press the slide bracket until it is flush with the
outer edge of the mounting rail; then, tighten the screws.
c. Attach the slide bracket to the left rear side of the rack enclosure.
1) Align the holes on the slide bracket with the cage nuts on the rear
mounting rail.