Table of Contents
Advertisement
Installing the computer in the rack enclosure
In this section, you will use the following parts:
Four long screws
Two cage nuts
One cable-management arm
Cable ties
To install the computer into the rack enclosure:
1. If you have not done so already, install a cage nut in each front
mounting rail in the marked positions, as shown.
2. Position the computer horizontally, with the 3.5-inch drive bays on the
top.
3. Align the inner slides of the computer with the slide rails; then, slide
the computer onto the outer slide, until the slide rails click into place.
Note: When the computer is fully extended, safety latches on the slide
rails lock into place. This prevents the computer from being
accidentally pulled out too far and dropped. To release the
safety latch, press in.
Appendix B. Rack mounting your computer
143
Advertisement
Table of Contents
Troubleshooting
