IBM IntelliStation 6866 Hardware Maintenance Manual page 44

To prepare the Type 6866 for installation in a rack enclosure:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Remove the rubber thread protectors on the two bolt studs near the power supply
11. Remove the screw between the two bolt studs (as shown in the following
12. Install the cable-arm bracket onto the two bolt studs on the rear of the computer.
13. Attach the inner slide section of each slide rail to the side of the computer.
36
IBM IntelliStation Type 6866: Hardware Maintenance Manual
Remove the left side cover.
Remove the top and right cover (secured by four slotted screws).
Place the computer on its right side to gain access to the inside.
Reach in and remove the four feet at the bottom of the computer.
Move the computer back to the tower position.
Install the new right side cover using three slotted screws.
Place the computer on its right side.
Install the new left side cover (the left cover has a thumbscrew attached). Tighten
the thumbscrew.
Install L-bracket part number 20L1419 on the left and L-bracket part number
20L1418 on the right, using two slotted screws per L-bracket.
(as shown in the following illustration).
illustration).
This cable-arm bracket is secured using two 3.5 mm flange nuts which are
provided in a plastic bag taped inside the CD-ROM drive cover.
Note: This cable-arm bracket will not attach to the computer unless you have
first removed the screw near the power supply.
a. Pull the inner slide until the safety latch locks.
b. Press the safety latch; then, pull the inner slide firmly until it detaches from
the outer slide rail.