If YES, proceed to c 003 d .
c 002 d
If the Power Management feature is enabled, do the following:
1.
2.
3.
4.
5.
6.
7.
c 003 d
Run the Diagnostic programs. If necessary, refer to "Running diagnostics tests" on
page 6.
•
•
2
IBM IntelliStation Type 6866: Hardware Maintenance Manual
Start the Configuration/Setup Utility program (see "Setup Utility program" on
page 5.)
Select Power Management from the Configuration/Setup Utility program menu.
Select APM.
Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow (←) or
Right Arrow (→) to change the setting.
Select Automatic Hardware Power Management.
Set Automatic Hardware Power Management to Disabled.
If the problem persists, continue to c 003 d .
If you receive an error, replace the part that the diagnostic program calls out or go
to "Diagnostics" on page 6.
If the test stops and you cannot continue, replace the last device tested.