BIG ASS FANS Isis Installation Manual page 39

Limited access fan controller and controller remote operation
As a convenience, the fan controller and the controller remote sets are factory paired by Big Ass Fans. See the previous page for wiring
instructions.
To start the fan, tap the upper portion of the pushpad once. The fan may take up to 30 seconds to start rotating. To increase fan
speed, press and hold the upper portion of the pushpad. To decrease fan speed, press and hold the lower portion of the pushpad.
To stop the fan, tap the lower portion of the pushpad once. To disable the fan, pull out the clear tab at the bottom of the controller.
Note: The Limited Access Controller is only necessary if you are utilizing the Limited Access wiring method described on the previous
page.
Wall Controller
Speed
Indicator
LEDs
Set
Pushbutton
WWW.BIGASSFANS.COM
Isis
®
Alternative Wiring Methods (cont.)
Pushpad
Clear Tab
©2011 DELTA T CORP.
Status LED
Programming
Pushbutton
DBA BIG ASS FAN CO. ALL RIGHTS RESERVED
Controller Remote
31