2. Attach locking carabiners to guy wire clamp
Secure the four (4) locking carabiners to the guy wire clamp as shown.
Securely tighten the carabiners.
3a. Attach beam clamp (angle iron mounting)
The guy wire should be at a 45° angle from the extension tube (see illustration on the
following page). Attach the beam clamp to an angle iron accordingly.
Fasten the small eyebolt and nut onto the beam clamp (the nut will be on the outside of
the beam clamp).
Loop the guy wire through its crimped end to secure it to the eyebolt as shown.
Guy Wire Hardware (BAF-Supplied):
a. 1/4" Beam Clamp
b. 1/4-20 x 1" Eyebolt
c. 1/4-20 Hex Nut
d. Guy Wire
3b. Attach eyebolt (wood frame mounting)
The guy wire should be at approximately a 45° angle from the extension tube (see the
illustration on the following page). Attach the eyebolt on wood frame accordingly.
Loop the guy wire through its crimped end to secure it to the eyebolt as shown.
Guy Wire Hardware (BAF-Supplied):
a. 1/4-20 x 1" Eyebolt
b. Guy Wire
WWW.BIGASSFANS.COM
Isis
®
Installing Guy Wires (cont.)
©2011 DELTA T CORP.
DBA BIG ASS FAN CO.
a
ALL RIGHTS RESERVED
21
a
b
c
d
b