4B. Fasten Double Angle Irons To Roof Structure Mounting Points - BIG ASS FANS Isis Installation Manual

12

4b. Fasten double angle irons to roof structure mounting points

CAUTION: The angle irons must be fastened to the roof structure at each end.
CAUTION: The angle irons with fan mounting holes should be positioned on the inside, facing each other.
Fasten the angle irons to the roof structure mounting points at each end with customer-supplied Grade 8 hardware as shown. Do not
tighten the hardware until the fan has been mounted to the angle irons.
Proceed to step 5.
Angle Iron Hardware (Customer-Supplied):
a. (8) 1/2-13 Bolt
b. (16) 1/2" Washer
c. (8) 1/2" Nut
a
b
d
b
c
WWW.BIGASSFANS.COM
Isis
Mounting Method: Angle Irons (cont.)
©2011 DELTA T CORP.
®
Angle Iron Hardware (BAF-Supplied):
d. (8) 3" Square Washer (see diagram)
Ø 9/16"
(1.4 cm)
DBA BIG ASS FAN CO. ALL RIGHTS RESERVED
Square Washer
3"
(7.6 cm)
3"
(7.6 cm)
Thickness:
1/4" (6 mm)