Electrical Installation Safety; Power Requirements - BIG ASS FANS Isis Installation Manual

WARNING: To reduce the risk of electric shock, wiring should be performed by a qualified electrician! Incorrect assembly
can cause electric shock or damage the motor and the controller! Hazard of electrical shock!
WARNING: The installation of a Big Ass Fan must be in accordance with the requirements specified in this installation
manual and with any additional requirements set forth by the national electric code (NEC), ANSI/NFPA 70-1999, and all
local codes. Code compliance is ultimately YOUR responsibility! Failure to comply with these codes could result in
personal injury or property damage.
CAUTION: The Big Ass Fans product warranty will not cover damage or failure caused by improper installation.
WARNING: Exercise caution and common sense when powering the fan. Do not connect the fan to a damaged or
hazardous power source. Do not attempt to resolve electrical malfunctions or failures on your own. Contact Big Ass Fans
at 1-877-BIG-FANS if you have any questions regarding the electrical installation of this fan.
CAUTION: The fan must operate on a dedicated circuit with a dedicated neutral. Failure to install the fan on a dedicated
circuit will cause the fan to operate improperly.

Power requirements

WWW.BIGASSFANS.COM
Electrical Installation
Fan diameter Input power
8 ft (2.4 m) 110–125 VAC/60 Hz
10 ft (3 m) 110–125 VAC/60 Hz
12 ft (3.7 m) 110–125 VAC/60 Hz
Wall Controller with Wallplate
©2011 DELTA T CORP.
Isis
®
Required Full load
circuit size amps
10A
10A
10A
DBA BIG ASS FAN CO. ALL RIGHTS RESERVED
3.9
3.9
3.9
25