Fax Direct Transmission; Cancelling Direct Transmission - Kyocera ECOSYS M3540idn Operation Manual

Sending Faxes > FAX Direct Transmission

FAX Direct Transmission

Scans all originals into memory, then dials and sends. Scanning of the originals starts after the connection is made with
the receiving system, allowing you to verify that each page of the fax has been properly sent.
Setting for Direct transmission
On
Off
NOTE
In direct transmission, you can designate only one destination for one transmission.
In the basic screen for sending, press [Direct]. This selects the direct
transmission method and the keys on the touch panel are highlighted.

Cancelling Direct Transmission

During direct transmission, to cancel communication during transmission, press the [Stop] key on the operation panel or
[Cancel] on the touch panel. The originals that have been scanned are ejected, and the screen returns to the send
default screen. When originals remain in the document processor, take them out.
NOTE
In some cases, transmission may take place even if the [Stop] key or [Cancel] is pressed.
Starts direct transmission.
Dials the receiving system, and after the communication has started, originals are
scanned.
Starts memory transmission.
After originals are scanned into memory, the communication starts.
3-21
Description
Ready to send.
FAX
On Hook Chain
Address Book Ext Address Book
Functions
10:10
Dest. :
Check
Direct
Recall Add Dest.
One Touch Key
Favorites